Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across West Hills
Caps and crowns fail quietly here, and the fix is usually straightforward. A chimney cap and crown job in West Hills typically runs $285 to $1,450 depending on whether we’re replacing a single-flue cap, fitting a custom multi-flue unit, or repairing and coating a cracked masonry crown. Homes off Valley Circle Boulevard and up into the foothill streets around Box Canyon tend to need cap work sooner than the flat ranch tracts near Fallbrook Avenue, because wind and tree debris hit them hardest. We connect you with local professionals who know that difference. Call (855) 337-1817.

Why West Hills Homeowners Call Chimney Sweep West Hills for Chimney Cap & Crown
We work West Hills properties where a single house can carry two or three flues, a masonry chimney from the 1960s, and a factory-built insert added later. That mix is normal here. It’s also where generic cap work goes wrong, because a cap sized to the masonry footprint doesn’t necessarily clear the appliance listing underneath it. Our technicians have up to 9 years of experience reading that difference before a cap comes off the shelf.
Neighbors pass our name along because we stay in the diagnostic lane first. Nothing gets recommended without an inspection you can look at with us, and the cap and crown work we quote is priced per job in writing before anything gets booked. We answer 24/7 by phone and dispatch Sunday through Friday, 7am to 7pm.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in West Hills
Our chimney cap & crown team covers the whole sequence, from pulling a bent cap off a windswept hillside chimney to resealing a spalled crown before the first winter rain.
Cap Installation
New cap installation in West Hills means matching the unit to what’s actually venting the chimney, not just measuring the top. Single-flue masonry chimneys on the older ranch homes take a standard cap fine. Hillside customs with pre-fab units need a cap that respects the manufacturer’s clearance, and we spec to that listing.
Cap Replacement
Replacement is one of the most common calls after a Santa Ana wind event. Original caps on 1950s-60s masonry corrode or lift loose, and once a cap is off, the flue is open to rain and animal entry. We swap it with a correctly sized unit, and the whole job usually books and finishes in one visit.
Crown Repair
A cracked or spalling crown lets water track down the masonry to the damper and firebox. We repair the crown surface and reshape the slope so water sheds away from the flue liner and smoke chamber. On older West Hills masonry, repointing around the crown is often part of the same job.
Crown Coating
Coating protects a crown that’s still structurally sound but drying and hairline-cracking. We use Gelco crown coating to seal the surface against the wet-winter cycle that follows dry Santa Ana winds. Coating is cheaper than a rebuild and holds up well when the crown hasn’t lost its shape.
Trusted Brands We Service in West Hills
We work with the materials chimney professionals specify: Gelco for crown repair and coating, Olympia Chimney and Famco for caps and venting components, plus HeatShield and DuraFlex when a cap or crown job turns up a liner problem underneath. Knowing these products well means we can size and specify correctly the first time instead of ordering generic parts and hoping they clear. For West Hills homes with factory-built chimneys, that matters more than usual.

See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in West Hills Homes
- Caps blown loose on ranch masonry. After Santa Ana winds, original single-flue caps on 1950s-60s homes skew or lift. Once they’re gone, the flue is open to rain and nesting animals.
- Cracked and spalling crowns. Wind-drying followed by wet winters cracks older masonry crowns. Water then tracks down to the firebox and damper before anyone notices.
- Generic caps on factory-built units. 1980s-90s hillside customs often have pre-fab metal chimneys with tight clearances. A generic cap can restrict draft or void the appliance listing.
- Debris-packed screens in the canyons. Box Canyon-area properties collect drought-stressed tree debris in cap screens, which blocks draft and prompts some homeowners to pull the cap entirely.
Pricing for Chimney Cap & Crown in West Hills, CA
A typical single-flue cap installation in West Hills runs $285 to $475. A custom or multi-flue cap for a hillside home with two or three flues runs $550 to $1,100, and crown repair with coating lands around $450 to $1,450 depending on the size and condition of the crown. What moves the number is the number of flues, whether the appliance is masonry or factory-built, and how much repointing the crown needs. Every price is set per job by a written estimate after inspection, and the estimate is free. Call (855) 337-1817 for an exact quote.
We Also Serve Cities Near West Hills
West Hills sits close to a lot of the same foothill and valley housing, and we connect homeowners across the area with local chimney professionals: Bell Canyon to the west, Canoga Park and Woodland Hills to the east, and Hidden Hills just south. Same inspection-first approach, same cap and crown scope, whichever side of the hills you’re on.
Serving West Hills, CA – Our Local Coverage Area
We serve West Hills and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in West Hills
Yes. Each flue is a separate opening, and a single-flue chimney with two fireplaces typically has two caps and one shared crown, so both need checking. A cap that’s blown loose on one flue leaves that opening exposed even if the other is fine. We inspect both on the same visit. Call (855) 337-1817 for a free estimate.
Yes. Factory-built metal chimneys in the hillside customs here carry tight manufacturer clearances, so the cap has to be sized and clearanced to the appliance listing rather than the masonry footprint. A generic cap that fits the top visually can still restrict draft or void the listing. We spec to the listed unit. Call (855) 337-1817 for a free estimate.
Look for hairline cracks across the top, a lifted or skewed cap, and any crumbling at the crown edges. Wind-drying opens cracks and then the next rain drives water in. If you see any of that, get it looked at before winter. Call (855) 337-1817 – estimates are free.
Coating is enough when the crown is sound but drying and hairline-cracking. If the crown has lost its slope or is spalling down to the masonry, it needs repair and reshaping before coating, or water keeps tracking to the damper. We tell you which one you’re looking at from the inspection. Call (855) 337-1817 for a free estimate.
NFPA 211 calls for an annual inspection regardless of how often you burn, and most West Hills homeowners land in that category given fireplace use is concentrated in December through February. Fewer burns still means creosote and wind-driven crown wear. A yearly check catches both. Call (855) 337-1817 for a free estimate.
Call (855) 337-1817 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep West Hills.